CarSeatFitfits your kid · fits your car

Turn2Me › fit in › Toyota Sienna

Will the Graco Turn2Me fit in a 2011–2020 Toyota Sienna?

Yes — the Graco Turn2Me fits a 2011–2020 Toyota Sienna.
The Turn2Me is about 19.5" wide; the Sienna's usable rear bench is about 54". It fits one rear position comfortably. Three across is tight (58.5" needed vs 54").
19.5"Turn2Me width
54"Sienna rear bench
Tightthree across
NHTSA Ease-of-Use
🔗 Amazon link is an affiliate link. It will earn a commission once our Amazon Associates application is approved — at no extra cost to you.

What fits this Sienna

ℹ️ Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip. The Turn2Me's width (Graco published spec (~19.5 in widest point; approximate)) and the Sienna's rear-bench width (Toyota dimensions + owner measurements (approx)) are both approximate — confirm with a test-fit before buying.

Common questions

Will the Graco Turn2Me fit in a 2011–2020 Toyota Sienna?

Yes — the Graco Turn2Me (19.5" wide) fits a single rear seating position in a 2011–2020 Toyota Sienna. Three across is tight — its rear bench is about 54" and three of these would need 58.5".

Can you fit three Turn2Mes across a Sienna?

Probably not — three Turn2Mes need about 58.5" but the Sienna's usable bench is only about 54". Consider a narrower seat — see our narrowest-seats guide.

Sources: seat ratings & modes — NHTSA (pulled 2026-06-17); dimensions — manufacturer specs and owner measurements. Informational only — built from NHTSA public car-seat ratings and published seat/vehicle dimensions. This is not a safety certification and not a substitute for the seat and vehicle manuals. Always confirm the fit and install yourself before every trip.